ウォーキングフロアセミトレーラー

Fliegl SDS 390 Schubboden 92m³ hydr. Heck

Please note: archive images! Vehicle may currently be in use!
#Chassis – haulage semi-trailer
- Fine-grain steel welded construction, lightweight design up to the landing legs
- Fifth-wheel plate with replaceable 2" kingpin
- Preparation for lashing eyes in the floor at the sides
Itjdpfxjz Ti A Ds Akgen
- 24 t 2-speed landing gear, one-side operation, with straight lower section
- Pull-out ladder at rear
- Side-mounted door stays
- Wheel chocks with holder
- Aluminium side underrun protection
- Steel rear underrun protection with wide Fliegl mudflaps
- Quarter-shell mudguards
- Rear ram protection (corner protection)
- Aluminium ladder 3300 mm, with side-mounted holder
- Tarpaulin pole with holder
- Plastic toolbox with drawer and shelf, W=650 / H=520 / D=670 mm
#Axles + suspension
- SAF disc brake axles with 430 mm disc diameter, air suspension
- 1st axle: automatic lift axle incl. forced lowering and traction help, actuation "3x braking"
#Braking system
- Dual-line air brake system, spring brake parking brake
- 2 non-interchangeable coupling heads at front
- EBS (electronic braking system) with EBS socket at front
- Raise & lower valve
- Vehicle stability system
#Wheels and tyres
- 385/55 R22.5", make at manufacturer's choice
- Steel rims, factory silver
#Electrics
- 24 Volt, multi-chamber lamps
- Yellow LED side lighting
- 2 white front position lights
- 2 white/red rear outline marker lights
- 2 x 7-pin non-interchangeable sockets at front
#Moving floor – hydraulics
- Hydraulic cylinders with sliding mechanism installed in the floor
- Dual-circuit hydraulics
- Forward/reverse switching and on/off electrically via radio remote control
- Drive system make Keith Runningfloor
- Moving floor power supply via sidelights
- Hydraulic operation via truck PTO
- Hydraulic connection with hose at front wall and screw-type plug of high-pressure rotary coupling NB = 48 mm
- Note: dual-circuit hydraulic system required!
- Recommended pump output: max. 223 ltr/min (180 ltr/min recommended)
- Pressure: max. 210 bar
- Oil tank capacity: min. 200 ltr
#Moving floor – floor
- Moving floor with rear wear plate, Running Floor
- Aluminium floor slats, 6 mm floor profile, ribbed design
- Prepared for retrofitting a floor protection sheet
#Moving floor – body
- Aluminium box body made of high-quality, abrasion-resistant material
- Front and side walls of aluminium hollow profiles, welded all round at the top to a wide special aluminium reinforcement profile, welded into a special frame at the bottom
- Moving inner bulkhead (travels with the floor) for better unloading
- Reinforced tarpaulin flaps at bottom
- Hydraulic rear wall with large upward opening, robust design, with radio remote control, operable only with roof open
- Standing platform with ladder access on both sides (left/right in direction of travel) and railing, for opening and closing the roll-up roof tarpaulin
- Removable, swivelling cross bows for tarpaulin support + tarpaulin support at front on front wall and at rear on rear wall
- Hydraulic roof with tarpaulin, operable via radio remote control
#Registration / plates
- Germany
- With Dekra inspection and expert report
Please note: archive images!