幌付きオープンセミトレーラー

FLIEGL SDS 390 Gardine Mega

Chassis Semi-Trailer for Haulage
Fine-grain steel welded construction, fifth wheel plate with replaceable 2" kingpin
Outer frame slightly sloped with "Load-Lock profile" for lashing strap attachment; if equipped, note: to hook in straps when side boards are mounted, the boards must be opened!
24 t two-speed landing gear, single-side operation, with straight lower part, without compensating slide
Note: Free landing leg corner spacing or free rear swing radius approx. 1930 mm without landing legs, pull-out ladder at the rear, door holder on the side
2x wheel chocks with holder
Aluminium side underrun protection
Galvanized steel rear underrun protection
Quarter-shell mudguards before the 1st axle and behind each axle
With anti-splash mudflaps behind each axle
Rear impact guard, double-sided pallet stop approx. 15-20 mm high, bolted design; loading height reduced by approx. 15-20 mm
Plastic toolbox with drawer and insert shelf, w=650 / h=520 / d=670 mm, lockable with padlock (padlock not included)
Axles & Suspension
SAF disc brake axles
Axle/chassis laser alignment for reduced tire wear and fuel consumption, air suspension, no lift axle
Braking System
2-line compressed air brake system, colour-coded line routing for easy service
Spring-loaded parking brake
2 unmistakably keyed coupling heads at front, no connection line
EBS, Electronic Braking System with EBS socket at front, no connecting cable
Attention: The trailer may only be towed by towing vehicles that ensure the ABS is effective!
With raise & lower valve
Vehicle stability control system
Wheels and Tyres
435/50 R19.5” make according to manufacturer’s choice, alternatively 385/55 R19.5
Steel rims, factory silver
Electrics
24 Volt, multi-chamber lamps, yellow LED side marker illumination
2 white position lights front
2 white/red lane marker lights rear
2 x 7-pin and 1 x 15-pin unmistakably keyed sockets at front, no connecting cables
Floor
Birch plywood panels approx. 30 mm thick, laid on longitudinal crossbars, high point load bearing capacity for forklift axle load up to max. 7100 kg
Body
Body mounted
Front Bulkhead / Corner Posts
2,580 mm high, steel corner posts, high-volume design, mechanism for side curtain release at front wall
"Crash Blocker", lower inside approx. 140 mm high steel impact protection
Intermediate Posts
3 pairs of sliding posts, adjustable along full length, with four multipocket sockets and long socket at bottom
3 pairs of post positions
Insert Slats
5 rows of wooden insert slats
Rear Wall / Rear Corner Posts
Rear steel corner posts up to lower edge of roof, curtain attachment with round tube and tensioning ratchet
Rear portal doors, double-winged, each with 2 internal rod locks
Curtain
Curtain with welded horizontal and vertical belts
Tension locks of stainless steel
Roof
Sliding roof, rear lift-up, can be slid from rear to front, L-roof rail for automotive industry, interior width between roof rails approx. 2,490 mm, curtain colour: white
Roof non-elastic, minimal deflection of roof rail during loading and unloading
EcoLift - roof can be raised by approx. 380 mm on both sides, gas strut assisted, 3 driving positions at front: internal height front approx. 2900 mm/2950 mm/3000 mm, set to approx. 3000 mm
Giedpfxex Sqmrs Ag Ujl
Optimized rain gutter at rear, top of rear hoop, above doors

この広告は自動翻訳されています。翻訳ミスがある可能性があります。