ティッパー

Fliegl DHKS 390 31 cm³

Further information
Chassis tipper semi-trailer
Fine-grained steel welded construction, in basic lightweight design, fifth wheel plate with interchangeable 2 kingpins
Patented curved front end
Telescopic support in the middle, unhitching with load not possible, when unhitched the vehicle must be at an angle to the rear.
Wheel chocks with holder
Underride guard, foldable
Half-shell mudguards
Integrated mudguard holder Stone-repellent surface
Itsdpfei Rivdsx Afmon
with anti-spray flaps on last axle only
Tarpaulin pole with bracket
Tow hook at the rear
Axles+suspension
SAF disc brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Axles in off-road version,
Air suspension
1st axle automatic lift axle, including forced lowering and starting aid, actuation of 3x brakes (starting aid is functional up to an axle load excess of 30% and up to a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism 10-year warranty against rusting through
Brake system
2-line compressed air brake systemColor-coded cable routing for easy servicing.
Spring-loaded parking brake
2 interchangeable front clutch heads, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
with lifting & lowering valve
Vehicle stability system
Automatic tilt lowering with shut-off valve
Wheels and tires
385/65 R22.5
Steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red rear lane departure lights
2 x 7-pin interchangeable sockets at the front, without connecting cable
Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chlorinated, with HDK screw socket, fixed part, NW 48 mm (without hose connection).
Hydraulic actuation via truck power take-off
Troughs
Round steel body in Stone Master design made of highly wear-resistant HB 400/450 steel. Sloping front wall with external hydraulic en with access to front wall.
Greenline - conical and aerodynamic body shape
Bucket and brush holder on the outside of the front wall.
Membrane rear wall
Rear wall as swing flap with double-jointed hinge, resting on the outside with double hook lock. 2 clamping screws with toggle fasteners at the bottom side.
Side walls 4 mm thick throughout, base 4/5 mm thick, wear and weight-optimized design,
Standing platform with step, connection plate for air/electric and brake with large clearance for optimum operability.
Roller tarpaulin on one side for depositing in FR-right, with central locking in FR-left
Operating instructions
For salt, lime, etc. We recommend a tipping cylinder with a hard chrome-plated piston rod so that it is not attacked by the material and rusts.
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Germany
Test approval according to EC 2007/46
Body strength according to EN 12642
24/7 service hotline
Prepared for single-line license plate holder
Warning sign according to ECE - 70
Contour markings with reflective strips to ECE R 048, white at the sides and red at the rear
Paint finish
Frame DB 7350 nova gray10-year warranty

この広告は自動翻訳されています。翻訳ミスがある可能性があります。