ダンプセミトレーラー

Fliegl DHKA 390 25 m³ Revolution

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

More information
Chassis
Fine-grained steel welded construction, lightweight design, kingpin plate with 2 interchangeable kingpins
Curved front end, patented
without support leg
Wheel chocks + holder
Underrun protection, foldable
Semi-shell fenders
integrated fender holder, surface resistant to stone chipping
Towing hook at the rear
Axles + Suspension
SAF disc brake axles
Axle/chassis laser-measured to reduce tire wear and fuel consumption
Air suspension
1st axle automatic lift axle, incl. forced lowering and starting assist, actuated by 3x brakes (starting assist functional up to an axle load exceedance of 30% and a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism
Braking system
2-line compressed air braking system, color-coded lines for easy servicing
Spring-loaded parking brake
2 tamper-proof coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
with lifting and lowering valve
Vehicle driving stability system
Wheels & tires
385/65 R22.5, manufacturer's choice
Polished aluminum rim, manufacturer's choice
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pin socket at the front, without connecting cable
Hydraulics
Nwsdsi Ri H Sopfx Albsl
Low-pressure cylinder max. 170 bar, smallest stage hard chrome plated, with HDK screw connection, fixed part, NW 48 mm.
Actuation via hydraulic system connected to the truck's auxiliary drive
Tippers
Sloping front wall 5 mm thick, with external side walls made of 30 mm hollow chamber profiles, neatly welded, with upper edge profile to prevent material spillage. Inside with a ladder on the front wall
Shovel and broom holder on the outside of the front wall
Greenline - conical and aerodynamic tipper body shape
Membrane - rear wall
Rear wall as a hinged flap with double-joint hinge, externally supported with a double hook lock.
Rear wall with rubber seal Note! Heat resistant up to max. 170°C!
Floor continuously 5 mm thick, Brinell 110 Note! Only for the transport of sand, gravel and rolled gravel with max. grain size up to 20 mm! All other transport goods are excluded from the warranty!
Standing platform with ladder, connection plate for air/electric and brake with large clearance for best possible operation.
Rollover tarpaulin, one-sided for laying down on the right-hand side, with central locking on the left-hand side
Operating instructions
For the transport of salt, lime, etc., we recommend a tipping cylinder with a hard-chrome plated piston rod to protect against rust
The specified total weight is technically possible, depending on the cargo, the total weight may not be reached while observing the permissible axle/support and saddle loads. (Poor driving and handling behavior due to incorrect load distribution possible)
Country of approval/ Signage
Germany
with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Paintwork
Frame DB 7350 Novagrau
Tipper body R

この広告は自動翻訳されています。翻訳ミスがある可能性があります。