ダンプセミトレーラー

Fliegl ZHKS 350 - 25 m³

Further information

Chassis Semi-Tipper
Fine-grained steel welded construction in basic lightweight design, kingpin plate with replaceable 2-inch kingpin
Curved front end (patented)
24t 2-speed landing gear, single-sided operation, with straight base, without thrust compensation
Foldable underrun protection
Half-shell mudguards
Tow hook at rear

Axles & Suspension
SAF disc brake axles with 430 mm disc diameter
Axle/chassis laser alignment to reduce tire wear and fuel consumption
Axles in off-road specification
Air suspension
1st axle automatic lift axle, including forced lowering and starting aid
Hot-dip galvanized lift axle mechanism, 10 years warranty against rust-through

Braking System
2-line compressed air braking system, color-coded lines for easy service
Spring-loaded parking brake
2 fail-safe coupling heads at front, without connecting line
EBS, Electronic Braking System with EBS socket at front (no connecting cable included)
Note: The trailer may only be towed by tractors that ensure the effectiveness of the ABS!
With raise & lower valve
Vehicle stability system

Wheels and Tires
385/65 R22.5
Steel rims, factory silver
TPMS (Tire Pressure Monitoring System) according to ECE R 141, display via the tractor display, via EBS, without truck installation (prerequisite must be met in the truck. Only for standard tires)

Electrics
24 Volt, multi-chamber lights, side yellow LED lighting
Side yellow LED lights coupled with turn signal "flashing side marker lights"
2 white position lights at the front
2 white/red lane marker lights at the rear
2 x 7-pin fail-safe sockets at the front, without connecting cable

Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chromed, with HDK screw coupling, fixed part, NW 48 mm (without hose connection)
Operation hydraulically via truck PTO

Tipping Body
Steel round body in Stone Master design made of highly wear-resistant HB 400/450 steel.
Inclined front wall with external hydraulic unit and access at the front wall
Greenline - conical and aerodynamic body shape
Shovel and broom holder outside on the front wall
Membrane rear wall
Rear wall as pendulum flap with double-joint hinge, external with double hook locking. 2 clamping screws with wing latches at the lower sides
Side walls 4 mm thick throughout, floor 4/5 mm thick, wear and weight-optimized construction
Standing platform with access, connection plate for air/electricity and brake with large clearance for best possible operability
Roll tarp stored to the right, with central locking on the left

Country of Registration/Plates
Germany
With Dekra inspection and report (according to §13 EC-FGV)
Body strength according to EN 12642
24/7 service hotline
Njdpfx Agoi Ri Nfewjwc
Prepared for single-line number plate holder
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear

Paintwork
Frame DB 7350 Novagrau (Nova grey)
10 years warranty against rust-through
Landing legs black coated
Body in desired RAL color, single color
Roll tarp in desired RAL color, single color

Available with thermal insulation version!

この広告は自動翻訳されています。翻訳ミスがある可能性があります。