温：+50°C / +200°C　冷：-80°C / +100°C

CTS Temperaturschock-Prüfschrank TSS-70/130 130 Liter

CTS
Type: TSS-70/130
Water-cooled refrigeration unit
For sale is a high-quality thermal shock test chamber by CTS (Clima Temperatur Systeme), model TSS-70/130.
This device is designed for performing thermal shock tests and is typically used in industry, research, and quality assurance.

Application Areas:
- Material testing
- Aging tests
- Electronics and component testing
- Thermal shock and temperature cycling tests

Technical Specifications:

Type: TSS-70/130
Gbsdpsy Hkd Hofx Ahlep
Test volume: 130 liters
Temperature range:
- Hot chamber: +50°C to +200°C
- Cold chamber: -80°C to +100°C
Heating rate: approx. 6 K/min from ambient temperature to +180°C
Cooling rate: approx. 4 K/min from ambient temperature to -60°C
Temperature deviation:
- ±1 K over time
- ±2 K spatially
Temperature change rate:
- max. 100 K/min average for shock test mode (no radiant heat)
Transfer time between chambers:
- ≤ 15 min for -65°C to +200°C with 10 kg ICs
Changeover time:
- < 10 seconds

Electrical Specifications:
Connection: 400 V, 3/N, 50 Hz
Nominal power: approx. 17.2 kW
Nominal current: approx. 29 A
Site fuse: 32 A slow-blow
Connection: Cekon 32

Refrigeration System:
Refrigerant: R404A / R23
Water-cooled, low noise, fully hermetic

Features/Equipment:
- CTS control panel
- Microprocessor-controlled regulation and monitoring system
- Programmable operation (up to 100 test programs)
- Digital setpoint and actual value display
- RS232 interface
- 2 free switching channels for external device control
- Fault notification via volt-free contact
(Loadable up to 30 V DC, 2 A)
- EMC tested

Technical Construction:
- Hot and cold chambers
- Transfer basket with spindle drive
- Test chamber/transfer basket made of stainless steel (material no. 1.4301)
- Stainless steel wire insert basket
- Tube port NW 50 with sealing plug
- Compressed air connection 1/4" male
- Non-pressurized condensate drain R 1/2" female thread
- Safety door locking
- Lockable door with window

Dimensions (according to installation diagram):
External dimensions approx.: 2335 x 940 x 1820 mm
Installation clearance approx.: 1990 x 940 x 1652 mm
Test chamber internal dimensions: height approx. 410 mm, width approx. 480 mm, depth approx. 660 mm
Window: 300 x 300 mm

Additional Data:
Protection class: IP 22
Sound pressure level: < 60 dB(A)
Weight: approx. 950 kg
Average consumption during test cycle: approx. 8 kWh

Important information for your safety as a buyer!
The following points are performed on our offered chambers in advance:
1. Functional check and replacement of necessary components
2. If required, refill with legally compliant refrigerant
3. Leak test with certificate
4. After successful inspection, chambers undergo a documented test run.

Condition: used
Scope of delivery: see photos
(Specifications subject to change and errors excepted.)
For further questions, please feel free to contact us by phone.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。