ローローダ

Fliegl DTS 300

Additional Information
Low-loader semi-trailer chassis
Steel welded construction
Turntable with robust ball bearing race
Foldable rear supports
2 support wedges with holder
Aluminum side impact protection
Rear mud flaps covering the entire width
Semi-fender for 1st axle with anti-splash mud flap, anti-splash mud flap behind 2nd and 3rd axles
1 plastic toolbox with insert, w=620/h=360/d=440 mm, lockable with a padlock. (Lock not included)
Extendable widening sections to 3,000 mm (not in rear slope) (However, the track width of the construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the center of the loading area
Wooden planks 70 mm for widening to 3000 mm
Tie-down points low-loader
1 pair of ring tie-down points recessed at the front on the kingpin, each 5 tons
7 pairs of tie-down eyes at the top and on the side in the outer frame, each 10 tons
1 x at the front on the kingpin
6 x in the low bed
First tie-down point 250 mm from the front and last max. 250 mm from the rear, distance between tie-down points not greater than 1100 mm
5 pairs of frame pockets recessed in the outer frame, inner 70 x 40 mm, (can be converted to 5-ton ring tie-down points, not included)
2 pairs of folding tie-down points additionally, each 10 tons
1 x on the kingpin (protrudes)
1 x behind the last axle recessed in the floor
Coupling device trailer turntable
Drawbar with tested 40 mm drawbar eye
Axles + Suspension
SAF drum brake axles
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation (linkage compensation)
Wheels and tires
235 / 75 R 17.5
Optionally with M&S marking as per manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking system
2-line compressed air braking system
Spring parking brake
2 non-interchangeable coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connecting cable
Manufacturer: Wabco or Knorr
Note: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the side
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole non-interchangeable plugs at the front, with connecting cable
1 LED rotating beacon with holder, switched via parking lights (beacon removable)
2 pairs of warning panels, double LED illuminated and extendable to 3,000 mm
Floor
Kingpin at the front with steel/diamond plate surface
Storage box recessed in the transition slope to the kingpin
followed by 70 mm softwood floor, in the wheel arch area steel/diamond plate surface
Rear slope with 70 mm softwood floor
Low-loader area incl. rear slope 6,500 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
Additional ramp securing device foldable at the bottom (to prevent lateral slippage of the ramps, not in conjunction with lateral hydraulic ramp adjustment)
Covered with wood
With spring-assisted support
Operating Instructions
Lajdpfoi Riwfsx Ag Isc
For an axle load of 10,000 kg, an exemption permit is required, only indivisible loads are possible!!!
The specified total weight is technically possible; depending on the cargo, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and tracking behav

この広告は自動翻訳されています。翻訳ミスがある可能性があります。