汎用加工センター

Deckel Maho DMU 50 EVO Linear ( Teilüberholt)

Deckel Maho DMU 50 evo Linear with TNC 530 control from Heidenhain, in TOP condition

Technical data:

>> Year of manufacture 2006
>> Manufacturer: Heidenhain, type iTNC 530
>> Travels X500/Y450/Z400
>> C-axis 360 degrees
>> B-axis 0 degrees to 161.955 degrees
>> Tool holder HSK A63
>> Max. spindle speed up to 18000 rpm
>> Feed rate continuously programmable up to X, Y, Z 20000 mm/min
>> C-B axis continuously programmable up to rapid traverse speed
>> Rapid traverse Y- and Z-axis 50 m/min
>> X-axis 80 m/min (linear drive)
>> B-axis 40 rpm
>> C-axis 50 rpm
>> Tool magazine: Double gripper, 60 magazine slots
>> Table clamping surface Ø 500 x 380 mm
>> T-slot spacing 63/14H7
>> Table load 200 kg
Gedpfozg Dnvex Anfjiw
>> Dimensions and weight: approx.
>> Machine without control and attachments
>> Depth 3.0 meters, width 2.4 meters, height 2.6 meters
>> Weight approx. 7000 kg
>> Operating voltage 400 V
>> Electric handwheel Heidenhain HR 410
>> Power connection 17 kVA
>> Chip conveyor
>> Active spindle cooling
>> Mist extractor
>> IKZ 40 Bar
>> Coolant cleaning system (fleece filter system)
>> Spray gun
>> Visiport
>> Compressed air supply to the measuring system
>> Preparation for robot loading
>> 3D probe Heidenhain TS640
>> 3D Quick Set
>> Kinematics
>> Blum laser for tool measurement and breakage detection
>> Complete documentation

The following work has been carried out:

>> Main spindle overhauled
>> Complete maintenance: All coolant hoses and pneumatic hoses renewed, filters new, fluids and belts renewed. Scrapers, etc. Complete cleaning.
>> Geometrically measured (acceptance report)

About the machine:

Offered is a Deckel Maho DMU 50 evo Linear machining center with a TNC 530 3D path control from Heidenhain. The machine is in very good condition. The main spindle has been overhauled (replacement spindle) on the DMU, completely serviced, and an acceptance report has been created. Invoices for the overhaul of 42,000 Euros (net) are available. Take the opportunity to inspect and test the machine on site while it is powered up.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。