BIESSE Selco WNT 630

BIESSE Selco WNT 630

This BIESSE Selco WNT 630 panel saw was manufactured in 2022. It features a maximum cutting length of 3800 mm, saw blade projection of 108 mm, and a lift table capacity of 5 tons. Ideal for handling large panels up to 3660 x 2200 mm. If you are looking to get high-quality cutting capabilities, consider the BIESSE Selco WNT 630 machine we have for sale. Contact us for more information.

• Maximum cutting length: 3,800 mm
• Maximum saw blade projection: 108 mm
• Maximum gripper opening: 100 mm
• Minimum panel size on the lift table: 1,830 × 915 mm
• Maximum panel size on the lift table: 3,660 × 2,200 mm
• Maximum stack height: 630 mm
• Minimum loading thickness on the lift table: 10 mm
• Working table height: 985 mm
• Lift table load capacity: 5,000 kgMain saw and scoring unit
• Main saw motor: 18.5 kW (25 hp)
• Scoring saw motor: 2.2 kW (3 hp)
• Main saw blade: Ø 400 mm, 1 included
• Scoring saw blade: Ø 200 mm with trapezoidal teeth, 1 included
• Saw blade lift driven by a brushless motor and ball screw
• Pressure beam opening control
• DIGISET electronic alignment of the scoring blade with the main saw blade
• Scoring unit can be disabled from the control panel
• QUICK CHANGE system for both saw blades
• Saw carriage travel speed: 1–160 m/min, brushless drive
• Maximum pusher speed: 90 m/min, brushless drive
• Side alignment unit integrated into the saw carriage (0 mm + 3,500 mm as specified in the quotation)Loading and unloading equipment
Godpfozug E Hsx Adtoui
• Rear loading onto the lift table with powered rollers and automatic stack positioning at the zero point
• Powered rollers on the lift table for side loading
• Right-side loading and unloading with continuous operator control
• Two panel-counting devices for automatic loading of thin calibrated panels from 2.5 mm thick
• Automatic detection of the bottom support panel based on the thickness set in the machine parameters
• Six liftable pneumatic grippers in the standard configuration
• Two additional liftable pneumatic grippers with double lower fingers for mounting on the pusher
• Two pusher contact points
• Two front alignment stops
• Eleven standard roller modules and two additional roller modules with wheels
• One 2,050 × 850 mm unloading table with non-powered rollers, replacing the standard 2,050 × 620 mm air flotation table
• Two additional rounded air flotation unloading tables, each 2,050 × 620 mm
• One fan serving up to six air flotation tablesControl, maintenance and safety
• Windows-based PC control with flat-panel monitor, keyboard and mouse
• OSI Plus interface
• Panel measuring system for manual cuts
• Remote cycle start button with safety stop, located at the second or third table
• Automatic lubrication
• Safety guards and protective devices