ポータルマシニングセンター

WALDRICH COBURG VALUTEC

TECHNICAL DETAILS
X-axis: 4,000 mm
Y-axis: 3,000 mm
Z-axis: 1,500 mm
C-axis: -10 - 370°
B-axis: -5 - 95°

Table, longitudinal: 0 - 30 m/min
Milling and drilling unit, horizontal: 0 - 60 m/min
Spindle slide, vertical: 0 - 60 m/min
Spindle unit horizontal/vertical: 0-15 / 0-10 rpm

Clear height: 1,550 mm
Clear width: 2,500 mm

Table
Clear height between table and spindle nose: 1,550 mm
Clear width: 2,500 mm
Table width: 2,000 mm
Table length: 3,000 mm
T-slots, transverse direction: 22 H8 mm, spacing 250 mm
T-slots, longitudinal direction: 15 H7 mm (250 mm from the edge, 10 mm deep)
Max. table load: 12,000 kg

Drill spindle speed range
1st gear: 5 - 1,400 rpm
2nd gear: 25 - 6,000 rpm
Max. torque: 800 Nm
Drive power: 30 kW
Spindle slide cross-section: 400 x 400 mm

Tool system
Tool holder according to DIN 69893: HSK-A 100
Number of tool stations: 100
Max. tool weight: 30 kg
Max. tool diameter: 250 mm
Max. tool length: 500 mm
Station to station distance: 140 mm
Average chip-to-chip time: < 20 s

Feed rates
X-axis table longitudinal: 0 - 30 m/min
Y-axis milling and drilling unit, horizontal: 0 - 60 m/min
Z-axis spindle slide vertical: 0 - 20 m/min
C-axis spindle unit horizontal: 0 - 15 rpm
B-axis spindle unit vertical: 0 - 10 rpm

MACHINE DETAILS
Total machine length: 9,500 mm
Total machine width: 6,700 mm
Total machine height above floor: 6,200 mm

Coolant system
Pump pressure: 12 bar (AKM), 50 bar (IKM)
Delivery rate AKM: 40 l/min at 1 bar
Delivery rate IKM: 20 l/min at 40 bar at the spindle
Coolant principle: two-phase drum separator
Coolant volume: 1,500 L

Chip conveyor system
Usable width, longitudinal conveyor: 450 mm (2 units)
Usable width, cross conveyor: 225 mm (1 unit)
Mounted on both sides of the machine bed, cross conveyor with overflow transfer