角窓加工センター

OKOMA UF 2 EG OKOMA UF 2 EG

Profiling milling machine with 2 profiling spindles, hardware milling unit, and sanding unit

Technical data and equipment

1. Power supply and compressed air

* Electrical connection: 3-phase, 380 V, 50 Hz
* Compressed air requirement: approx. 13 NL/min
* Operating pressure: 8 bar
* Compressed air quality: according to Pneurop 6611

2. Profiling spindle 1

* Spindle arrangement: right
* Drive power: 11 kW
* Speed: 7,000 RPM
* Direction of rotation: clockwise and counterclockwise
* Spindle diameter: 40 mm
* Effective length: 252 mm
* Max. tool diameter: 230 mm

Vertical positioning:

* U-shaped movement of the profiling spindle
* Pneumatic cylinder with 120 mm stroke
* 2 tool positions
* Position detection via limit switches

Horizontal positioning:

* Pneumatic forward and backward movement
* Position detection via limit switches
* Automatic plunge function with adjustable plunge speed for tear-free milling
* Protective and extraction hood with extraction nozzle Ø 140 mm

3. Profiling spindle 2

* Spindle arrangement: right
* Drive power: 11 kW
* Speed: 7,000 RPM
* Direction of rotation: counterclockwise
* Spindle diameter: 50 mm
* Effective length: 272 mm
* Max. tool diameter: 230 mm

Vertical positioning:

* U-shaped movement of the profiling spindle
* Pneumatic cylinder with 90 mm stroke
* 3 tool positions
* Position detection via limit switches

Horizontal positioning:

* Pneumatic forward and backward movement
* Position detection via limit switches
* Protective and extraction hood with extraction nozzle Ø 140 mm
Kdjdez S Nrpopfx Akgeu

4. Hardware milling unit EG

* Spindle arrangement: right
* Drive: Three-phase motor, 3 kW
* Speed: 6,000 RPM
* Spindle diameter: 30 mm
* Effective length: 47 mm

Positioning:

* Vertical positioning: not available
* Horizontal positioning: pneumatic forward and backward movement
* Position detection via limit switch (rear position)
* Protective and extraction hood with extraction nozzle Ø 80 mm

5. Stop system

* 1. Stop in front of profiling spindle 1:
* Manual chip removal
* Quick adjustment via parallelogram guide
* 2. Stop between profiling spindle 1 and 2:
* Pneumatically adjustable chip removal
* 3. Stop behind profiling spindle 2:
* Fixed stop

6. Sanding unit

* Sanding unit with automatic infeed and outfeed

7. Feed device

* Roller spacing (center to center): 130 mm
* Roller diameter: 110 mm
* Roller width: 50 mm
* Feed device can be swiveled away
* Pneumatic control of the working stroke

8. Support rail for edge milling

* Rail length: approx. 3,000 mm
* Adjustment range forward: approx. 100–600 mm

この広告は自動翻訳されています。翻訳ミスがある可能性があります。