フライス盤

Mikron UM600

Good used CNC milling machine with low hours.
Used exclusively for repairs and very small production runs.
Extensive assortment of tool holders as shown in the photos, including vise, chucks, cutters, plates, and tap holders. Also equipped with a Benz high-speed spindle for wet operation up to 25,000 rpm.

TECHNICAL DETAILS
Drive power at 44% duty cycle: 15 kW
Drive power at 100% duty cycle: 6 kW
Max. torque: 50 Nm

Machining spindles (vertical and horizontal)
Max. spindle torque at 44% duty cycle: 800 Nm
Number of gearbox stages: 4
Adjustable speed range (vertical and horizontal): 10 – 6,000 rpm
Toolholder / pull stud: SK 40 / DIN 69871
Max. tool weight: 13 kg
Tool diameter: 130 mm

Automatic travel distances
Spindle longitudinal feed (X-axis): 600 mm
Spindle transverse feed (Y-axis): 500 mm
Spindle vertical feed (Z-axis): 450 mm

Feed drives (AC)
Programmable feed rate X / Y-axis: 0 – 15,000 mm/min
Lhsdpeywn Sijfx Ab Ued
Programmable feed rate Z-axis: 0 – 12,000 mm/min
Rapid traverse rate X / Y-axis: 15,000 mm/min
Rapid traverse rate Z-axis: 12,000 mm/min

Coolant tank capacity: 150 l
Flow rate: approx. 20 l/min

Clamping table
Table size: 520 × 900 mm
Number of T-slots: 4
T-slot width: 14 H7
Table load capacity: 400 kg

Tool changer TCD 44
Tool stations: 22
Tool diameter: 80 / 130 mm
Max. tool length: 350 mm
Max. tool weight: 6 kg
Max. workpiece weight in drum magazine: 200 kg
Chip-to-chip time: 20-25 s
Tool change time: 12 - 16 s

Electrical connection data
Total installed nominal power: 15.8 kW
Usable and connected load: 12.3 kW
Operating voltage and frequency: 3 × 400 V / 50 Hz

この広告は自動翻訳されています。翻訳ミスがある可能性があります。