Professional pressure blasters for industry

Mammut 200 liter Druck-Sandstrahlgerät mit Quick-STOP Sicherheitsabschaltung

Our SAPI "Mammut" pressure blasting unit with a 200-liter tank capacity is suitable for all common blasting media. The blasting pressure can be continuously adjusted from 0.1 to 12 bar using the permanently installed pressure regulator. A water separator is also permanently installed on the blasting unit; this separates moisture from the compressed air and prevents the blasting media from clumping due to excessive moisture.

Our safety shut-off device is included for safe operation of the sandblaster. This starts and stops the blasting process by operating the hand lever mounted on the blasting hose.

Included in delivery:

SAPI pressure blasting unit "Mammut 200 L"
1 1/4" pressure regulator, permanently mounted
1 1/4" water separator, permanently mounted
SAPI safety shut-off

Technical specifications of the pressure blasting unit:
Precisely adjustable from 0.1 - 12 bar
TÜV-tested with certificate
1 1/4" fixed piping inside and outside
Rubber-coated metal cone with rubber seal
Generous hand hole
Rubber-coated metal cone with rubber seal
Large hand hole
Rubber-wheeled chassis
Abrasive dosing valve (suitable for all common blasting media)
Capacity: 200 l
Total height: 1,420 mm
Vessel diameter: 600 mm
Total diameter: 1,000 mm
Weight: approx. 140 kg
Dksdpfewc Rk Eox Anvjw

ADVANTAGES OF THE SAPI PRESSURE BLASTING UNIT with safety shut-off
Fastest start-up and shutdown times while maintaining compliance the regulations of the professional associations (VBG 48)

The pressure setting can be precisely adjusted before blasting – continuously adjustable from 0.1 to 12.0 bar

Lower abrasive consumption, as the pressure vessel remains permanently pressurized and there is no unnecessary run-on time

Upon restart, full blasting pressure is immediately available at the nozzle – no pressure build-up necessary → lower consumption & less wear on the hose

No condensate formation in the vessel, as it remains constantly pressurized → no venting or venting with every start/stop

Optimal abrasive dosing with a hardened fine dosing valve

Less compressed air required → noticeably lower diesel consumption

One-person operation, as the pressure can be displayed and adjusted directly on the pressure gauge – even without starting

No failure-prone components such as control valves, diaphragms, or seals → easy to maintain and reliable

Only the blasting hose in the safety shut-off device needs to be checked and replaced if necessary

この広告は自動翻訳されています。翻訳ミスがある可能性があります。