Cantilever rack

Kragarmregal einseitig Höhe: 3.000 mm Nutztiefe: 1.200 mm / Länge: 4.000 mm

Cantilever rack used: screw system in hot-dip galvanized design

Scope of delivery:

4 shelf uprights, height 3,000 mm with foot section, 1,200 mm usable depth

12 cantilevers with 1,200 mm usable depth, standard

Including longitudinal and diagonal braces for 1,300 mm spacing

Fastening material (screws, nuts and washers)

Chodpjmhhx Ijfx Aided
- (*Delivery time approx. 1 week)

- (*No damaged parts!)
- (*Reorder spare parts and extension possible at any time)

- (*Offer available in larger quantities: approx. 40 uprights in stock)

Detailed description:

- Stable steel construction made of IPE profiles (screw system)

- Hot-dip galvanized surface

- Shelf height 3,000 mm

- Load capacity per upright 2,250 kg

- Foot section and cantilever arms with 1,200 mm usable depth

Cantilever arms in Height adjustable in 100 mm increments
- 3 screwable cantilever arms per stand, standard (= 4 storage levels)
- Load capacity per cantilever arm 750 kg
- Including longitudinal and diagonal braces for 1,300 mm spacing
- Shelf length = 4,000 mm
- Including fastening material (without ground anchors)
- With assembly instructions and C4 load plates in accordance with DIN standard
- Expert advice by telephone
- Made in Germany
- Short delivery time
- On-site collection possible

Our cantilever racks are manufactured exclusively in Germany.

We offer reliable freight with registration before delivery.

The material is sensibly packed to enable easy unloading.

When installed outdoors, the load-bearing capacity is reduced by the wind and snow load.

The subsurface must be made of concrete, level and dowel-capable and must be able to bear the loads. The condition of the soil and load-bearing capacity as well as any official permits required must be checked and guaranteed by the customer.

The shelf supports must be anchored to the floor on site; anchoring to the wall is not necessary and not recommended.
According to the trade association, it is recommended that the shelf supports on the top storage level have a projection of at least 500 mm above the top edge of the supports.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。