Iwesa O-PC-SE-P pressing device for ceramic pins in rotor shafts

Iwesa O-PC-SE-P

Press-fitting device for ceramic pins in rotor shafts

Operating principle:

The ceramic pins are fed to a testing station via a vibrating feeder and a pneumatic hose, where the position of any existing one-sided bore is checked. This is done using an optical sensor.
Incorrectly positioned parts are conveyed to a collection container by a pneumatic slide.
Correctly positioned pins are fed to the singulator of the press-fitting tool via another pneumatic hose.

The actual press-fitting process is also carried out pneumatically with a roller bearing-guided plunger.
First, a manually adjustable pressure p1 is used to ensure that the pin is not pressed too easily into the shaft.
Then, with another manually adjustable pressure p2, the pin is pressed fully into the rotor shaft.
A disk spring pack preloaded with 5,000 N prevents excessive force from being exerted on the pin and shaft.

The rotor shaft must be manually inserted, removed, and clamped into the tool by an operator. This process is secured by a light curtain.

Design
Self-supporting station, integrated into a complete system, for press-fitting ceramic pins and balls.

Rotor shafts
Diameter: 5 - 20 mm
Length: 50 - 200 mm

Ceramic pin
Diameter: 3 mm
Length: 5 +/- 0.2 mm

Operating cycle
Performance: 15 cycles per minute

Safety
Protective door with safety switch
Cjdpfx Aijib H U Dsdohd
Light curtain, category 4
Emergency stop

Airborne noise emission
Continuous sound pressure level at the workplace: 70 dB (A)

Electrical connection
Voltage: 230 V AC
Frequency: 50 Hz
Fuse: 10 A

Compressed air connection
Operating pressure: 5 - 7 bar

Dimensions
L x W x H = 850 x 950 x 1020 mm
Weight: approx. 110 kg

Year of manufacture: 2003

Electrically adjustable work table

Documentation and circuit diagrams are available.

More press-fitting devices – new and used – can be found in our shop!
International shipping costs available on request!

この広告は自動翻訳されています。翻訳ミスがある可能性があります。