無垢材研磨ライン

HOMAG SANDTEQ W-700+B-700

Working height: 900 mm
Working width: 1,350 mm
Belt changing side: left
Workpiece thickness: 3 - 160 mm
Frequency-controlled feed speed: 4 - 20 m/min

Abrasive belt dimensions: 2,620 x 1,350–1,380 mm
Adjustable sanding belt blowing device with 5 settings

WRD WORKPIECE CLEANING ROTOR
Workpiece cleaning system with 16 rotating nozzles

MOBILE OPERATING TERMINAL
powerControl with powerTouch

SST SOFT STARTER
Inrush currents are limited to prevent voltage drops

GWRD BELT CLEANING PROGRAM
Upon activation, the machine automatically sets to a 10 mm workpiece thickness and activates the blowing rotors. After the feed belt is fully cleaned, the machine returns to its initial setting.

AAT EXTRACTION DAMPER CONTROL
Control of extraction dampers via the terminal (24 Volt DC, without extraction dampers included)

UPS EMERGENCY POWER SUPPLY FOR BELT CONTROL 1-3 PCS
Uninterruptible power supply for sanding belt oscillation in case of power failure

System consists of:
SANDTEQ W-700, PROFI SWB735/RRE – sanding from below
Wide belt sanding machine with three sanding units for processing wood or wood-like workpiece surfaces
Prepared to accept up to two auxiliary units, such as a cleaning brush, satinizing or structuring brush, and rotating cleaning nozzles.

Units:
I. R UNIT
Sanding unit with automatically adjusting contact roller
Profiled steel roller, 240 mm diameter
With grain compensation
Drive motor: 37 kW
Abrasive belt speed: 25 m/s

- Automatic locking of the sanding unit for fast belt changes and increased process safety
- Abrasive belt drives with electronic, wear-free brake
- Optical, touchless abrasive belt tracking
- Pneumatic abrasive belt tensioning with integrated belt edge compensation

II. R UNIT
Sanding unit with automatically adjusting contact roller
Rubber-coated roller, 240 mm diameter
Rubber hardness: 85° Shore
With grain compensation
Drive motor: 30 kW
Abrasive belt speed: 18 m/s

III. E UNIT
Sanding unit for installing a pressure beam

- Automatic locking of the sanding unit for fast belt changes and increased process safety
- Abrasive belt drives with electronic, wear-free brake
- Optical, touchless abrasive belt tracking
- Pneumatic abrasive belt tensioning with integrated belt edge compensation
- Protected storage area on the machine for additional sanding inserts

Drive motor: 22 kW
Abrasive belt speed: 2 – 18 m/s
Torque-dependent standby operation to reduce energy consumption.

ACP PNEUMATICALLY SUPPORTED PRESSURE BEAM
- Adjustable sanding pressure via pressure regulator
- Workpiece-controlled engagement and disengagement at the leading and trailing edges
- Various sanding inserts, 80 mm wide, with different felt hardnesses

Machine dimensions (L x W x H): 3,900 x 2,100 x 2,000 mm
Machine weight: approx. 7,500 kg

SANDTEQ B-700, PROFI SWT735/RRE – sanding from above
Wide belt sander with three sanding units for machining wood or wood-based workpiece surfaces
Units as above, additionally:
FBM FINISHING BRUSH
Brush unit with finishing brush
Bristles: horsehair
Diameter: 130 mm
Drive motor: 0.75 kW

Machine dimensions (L x W x H):
2,995 x 2,100 x 2,255 – 2,415 mm
Machine weight: approx. 6,500 kg
Lredoyw Ndmepfx Ab Uji

この広告は自動翻訳されています。翻訳ミスがある可能性があります。