パイロット押出紡糸ライン（ポリエステル用）

Fourne Barmag

PILOT EXTRUSION SPINNING LINE POLYESTER

MAIN PART WAS DESIGNED BY FOURNE IN 1997 FOR DSM TO MAKE TRIALS OF POLYESTER AND POLYAMIDES, MONO & MULTIFILAMENT.

>>

EXTRUDER DETAILS :

MANUFACTURER : FEP POLYMER
Iaedpfx Aozl Hz Neihsw
YOC : 1997

TYPE : EX 25 - 25 D
MAX. THROUGHPUT : CA. 7,0 KG/H (PA6), CA. 5,6 KG/H ( PP )
: CA. 8,2 KG/H ( PET )

NOMINAL SCREW DIA : 25 MM
SCREW LENGTH : 25 X D
SCREW GEOMETRY : SPECIAL 3-ZONE-SCREW

MIXING TORPEDO : CHANGEABLE ATTACHED TO SCREW END , CA 3 X D LONG

HEATING CAPACITY : CA. 3,2 KW / 4 ZONES

DRIVE : CA. 4,5 KW, AS- MOTOR MIT SCHNECKENGETRIEBE

ELECTRICALLY HEATED AND REGULATED TO MAX. 350 ° CELSIUS,
EQUIPPED WITH 3 TEMPERATURE CONTROL SENSORS, OVER-TEMPERATURE
MONITORING, WATER-COOLED FEED ZONE, REMOVABLE
ISOLATION AND BASIC FRAME, INCLUDING INERT GAS
IN THE INLET PIPE, EQUIPPED FOR THE SUBSEQUENT RECEPTION OF A
TORQUE CLUTCH ON THE GEARBOX END



>>>

SPINBEAM & MELT PIPE : ELECTRICALLY HEATED

SPINBEAM DESIGN : FOR 1 MONFIL OR 2 MULTIFILAMENT THREADLINES

SPINPUMPS : 1 = 2 X 2.4CC , 1 = 1 X 2.4 CC , 1 = 1 X 0.6 CC

SPINNERETTES : 42 / 59 / 72


>>>



QUENCH CABINET : FEP Polymertechnik Gmbh
YOC : 1995
TYPE : CROSSFLOW
Plant Nr. : 7.1396

>>>

WINDER : BARMAG
TYPE : SW4S
Auftragsnr : 10/0428
YOC : 1988


>>>

DRAW – STAND : EDMUND ERDMANN GMBH
TYPE : DRAWMOD 02/380-3/5/6 LM
YOC : 1995
COM. NR : 13/2492

CONTROLS COMPUTER : EDMUND ERDMANN
YOC : 1995
FABR. NR : 132492


>>>

PREHEATING OVEN : HERAEAUS Gmbh
Type : WU6100 , 500C , 3 Nipe, 400 V 11.4 A, 5.4 kW
YOC : 1997
FABR. NR : 97/11055


>>>

HOIST IN EXTRUDER AREA : HEBEZEUGFABRIK GMBH,
YOC : 1998,
CAPACITY : 0,7 TONS
LIFTING HEIGHT : 0,8 M