アルブルグ 520S-1500-400

Arburg 520S-1500-400

This 3s Arburg 520S-1500-400 was manufactured in 2016. It features a clamping force of 1600 kN, a screw diameter of 45 mm, and a servo-controlled dual-circuit pump system for precise movements. The SELOGICA direct control system with a 15-inch touchscreen enhances usability. Consider the opportunity to buy this Arburg 520S-1500-400 hydraulic injection moulding machine. Contact us for further details.

• Programmable and controlled build-up of clamping force; extended clamping program with 2 stages
• Hydraulic, servo-controlled ejector on moving platen
• Screw diameter: 45 mm (without nozzle)
• High wear-resistant version; sinter-metal check ring; CrN coating on screw and check ring
• Suitable for abrasive, corrosive and high-temperature thermoplastics
Kljdpsyg I Egjfx Ab Uep
• Technology level 2: servo-controlled, dual-circuit pump system with two regulated hydraulic pumps for precise, parallel movements
• Programmable nozzle contact force and holding pressure
• Continuous oil circulation with additional cooling and filtration
• SELOGICA direct control system with touchscreen process editor
• 15-inch (38.1 cm) display; multilingual interface (German, English, local language)
• Heating capacity zones 1–6: 3.6 kW each (230 V / 16 A)
• Cylinder heating temperature up to 450 °C
• OPC UA interface (MES/host computer connection)
• USB and CompactFlash interfaces for data storage
• Pneumatic supply with pressure regulator
• Cooling water distribution with adjustable circuits and flow indicators
• Electrical: 400 V / 50 Hz, with neutral conductor
• Hours: 13,361

Additional equipment

• None included as listed
• Robot/automation readiness: EUROMAP 67 robot interface; prepared for ARBURG MULTILIFT robot system