All-electric injection molding machine – only approx. 9,000 operating hours

Sumitomo (SHI) Demag IntElect2 100/470-250

ONLY APPROX. 9,000 OPERATING HOURS – FULLY ELECTRIC WITH ROBOT AND PERIPHERALS

In very good condition according to the seller's assessment, and with only approx. 9,000 operating hours: this Sumitomo (SHI) Demag IntElect2 100/470-250, manufactured in 2021, impresses with its low operating hours. The extensive equipment, including an SDR-5S robot, two HB-Therm temperature controllers, and material handling equipment, makes this machine an attractive overall package.

Fully electric Demag IntElect2 with robot and peripherals
This used Sumitomo (SHI) Demag IntElect2 100/470-250, manufactured in 2021, combines 1,000 kN clamping force with an injection unit of size 250. The plasticizing unit is equipped with a highly wear-resistant, corrosion-resistant 30 mm screw with an L/D ratio of 20, as well as a bimetallic cylinder.

Tooling space and process equipment
The tie bar spacing is 470 x 470 mm; the mold height is specified as 180 to 550 mm. Two hydraulic and one pneumatic core pull circuits, integrated hot runner control for 16 zones, and an eight-fold cooling water flow controller are included in the equipment. activeProtect and the process data acquisition system PDE complement the process monitoring.

Handling, temperature control, and material handling equipment
Bsdpfs Ahkfkex Akcoww
The documented scope of supply includes the Sumitomo Demag SDR 5S H&P linear robot with a 3 kg payload, two HB-Therm Thermo-5 HB-160Z1 temperature controllers, two integrated conveyor belts, as well as an additional Z-conveyor and a sprue separator. Interfaces include EUROMAP 67, EUROMAP 77 / OPC UA, and EUROMAP 82.1 / OPC UA.

Condition: very good, according to the seller's assessment. Operating hours: only approx. 9,000 h. Price and current availability are available upon request. I would be happy to assist you with the technical coordination of this used injection molding machine.

TECHNICAL DATA
Clamping force: 1,000 kN / 100 t
Injection unit: 250
Screw diameter: 30 mm; L/D 20
Max. injection speed: 200 mm/s
Tie bar spacing: 470 x 470 mm
Mold height: 180–550 mm
Ejector: 150 mm; 32 kN; 333 mm/s
Mains voltage: 400 V / 50 Hz
Machine weight according to nameplate: 5,290 kg

DELIMITATION OF THE SCOPE OF SUPPLY
The KOCH KKT 55 material drying system with the associated KOCH conveyor is not included in the quoted price of the Demag. The KOCH system can be purchased separately; price on request.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。