射出成形機

KraussMaffei Technologies GmbH KM 80 / 380 CX G01

Injection Moulding Machines Direct from the Manufacturer!
Fsdpfxey Rlmws Ag Ijpg

As the manufacturer KraussMaffei, we offer you our inspected and versatile stock machines:

The fully hydraulic CX series features particularly compact, efficient, and flexible two-platen machines. The very compact two-platen concept with cantilevered clamping provides generous space for peripheral equipment and optimal accessibility. Efficient and intelligent energy management with BluePower servo drive provides a powerful foundation to meet the highest demands and delivers the right solution for every application.

TECHNICAL DATA:
KM 80 / 380 CX G01 (Order 38648713)

CONTROL SYSTEM
• MC6 with TFT colour touchscreen with multitouch functionality

CLAMPING UNIT
• Clamping force: 800 kN
• Max. mould opening force: 55 kN
• Clear space (h x v): 470 x 420 mm
• Mounting plate (h x v): 670 x 670 mm
• Minimum - maximum mould installation height: mm (specify values if known)
• Maximum daylight: 750 mm
• Maximum mould opening stroke: 500 mm
• Ejector drive: hydraulic
• Ejector stroke: 150 mm
• Ejector force forward/backward: 23/10 kN
• Ejector speed forward/backward: 760 / 800 mm/s
• Maximum mould weight: 1000 kg

INJECTION UNIT
• Screw diameter/type: 40 mm / Standard (adaptable)
• Effective L/D ratio: 20
• Injection pressure: 1860 bar
• Stroke volume: 201 cm³
• Shot weight at max. stroke for PS: 183 g
• Injection speed: 100 mm/s
• Injection flow rate: 126 cm³/s
• Screw drive/speed: 295 rpm
• Plasticizing rate (standard): 12.3 g/s
• Nozzle contact force: 50 kN

ELECTRICAL PARAMETERS
• Connected load: 15.0 kW
• Installed heating capacity: 10.9 kW
• Power supply: 400 V / 50 Hz, 3-phase with neutral

WEIGHT AND DIMENSIONS
• Net weight with control cabinet: 3.55 t
• Length x width x height: 3.96 x 1.48 x 2.02 m

ADDITIONAL FEATURES
• Wear-resistant plasticizing
• BluePower full insulation for plasticization cylinder
• Open nozzle
• 1 additional heating circuit for nozzle heating
• Air valve, single (BWAP)
• Pneumatic control for hot runner shut-off, single
• Hydraulic core pull, single (BWAP)
• Euromap interface for handling: E18, E63
• Euromap interface (central computer): E67, E77
• Adaptive Process Control (APC)
• Injection-compression mode
• Graphical analysis package

The machine is located at our factory in Parsdorf and is available at short notice. Additional options can be offered upon request.

We look forward to your inquiry.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。