射出成形機

ENGEL e-cap 3440/420 T

ENGEL e-cap 3440/420 T injection molding machine
Basic data
• Manufacturer: ENGEL
• Model: e-cap 3440/420 T
• Year of manufacture: 2012
• Machine type: Fully electric injection molding machine
• Control system: ENGEL CC200
• Operating hours: 63,000 h
• Screw diameter: 80 mm

Technical data
Clamping unit
• Clamping force: 4,200 kN (420 tons)
• Clamping mechanism: Kneel-type, fully electric
• Opening stroke: 700 mm
• Minimum mold height: 350 mm
• Maximum mold height: 750 mm
• Mounting plate dimensions: 1350 × 1350 mm
• Column spacing: 920 × 920 mm
• Ejector stroke: 220 mm
• Ejector force: 120 kN
• Maximum mold weight: 6200 kg

Injection unit
• Unit size: 3440
• Screw diameter: 80 mm
• Injection volume: 1709 cm³
• Maximum injection pressure: 1950 bar
• Number of heating zones: 6

Equipment
• ENGEL CC200 control system
• Fully electric drives for all axes
• Energy-efficient ENGEL e-cap technology
• Very high precision and process repeatability
• Suitable for continuous 24/7 operation

Machine history
The machine has been used since new for the production of plastic buckets.
It has never been used for the production of PET caps, although the e-cap series was designed specifically for this type of application.
Lrodpfx Akjzlgi Heaju
The average cycle time was approximately 15 seconds.
As a result, the clamping unit has performed significantly fewer operating cycles than typical e-cap machines used for cap production, where the cycle time is usually below 2–4 seconds. This potentially indicates lower mechanical wear compared to machines operated according to their original intended purpose.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。