射出成形機

Arburg 370 E 600 - 290

Plasticizing cylinder assembly 35 mm (without nozzle) in highly wear-resistant version
Servo-controlled, programmable nozzle unit for injection unit 1
Highly accurate and reproducible mold positioning through electromechanical servo drive
Hydraulic core pull control for simultaneous, regulated movements; for both sequential and simultaneous movements, pressure and flow are programmable. Connections located on the moving platen.
Electromechanical, position-controlled ejector
Blow-off device 1 with pressure regulator
Electric mold height adjustment for adaptation to different minimum mold heights, adjustment range directly programmable via SELOGICA control
Electric, programmable conveyor belt
Sorting unit for separating good and reject parts during production, installed longitudinally below the clamping area
"Extended Monitoring" equipment package: Expansion of mechanical process monitoring for mold and machine for complex applications
"Extended Movement Functions" equipment package: Increased number of movement steps and intermediate stop functions
Freely configurable page for "Startup Parameters" to allow a selectable number of cycles to run with parameters different from the production parameters.
Additional socket combination, with 1 Schuko and 1 x CEE via automatic cutoff (1 standard included, max. 1 additional possible)
Extended mold protection
6 electric heating control circuits for mold heating, each max. 2 kW / 230 V
Interface for a coloring/dosing unit (volt-free contact)
Iodpfx Ahjxywxuj Ioa
"Quality Assurance" equipment package
Tie-bar extension +100mm for mold installation height
Integral picker

Machine is sold without material feed and peripheral devices.

この広告は自動翻訳されています。翻訳ミスがある可能性があります。