ティッパー・セミトレーラー

FLIEGL Sattelkipper Stahl- 27cbm

Chassis: Tipper Semi-Trailer
Fine-grained steel welded construction, fifth wheel plate with replaceable 2" kingpin
Curved front bulkhead (patented)
24-ton two-speed landing gear, single-side operation, with semi-circular lower section and straight connecting plate, with load compensation
Uncoupling under load is not possible; when uncoupled, the vehicle must be positioned sloped to the rear.
Free rear swing radius approx. 2,100 mm in rear position and approx. 2,600 mm in forward position!
2 wheel chocks with holders
Aluminum side underrun protection
Pneumatically folding rear underrun guard, operable via switch in the truck on PIN 14 (without truck installation) and manually on the trailer
Half-shell mudguards
Dlodpfxsxclg Se Agkoa
With anti-spray mudflaps only on the rearmost axle
Tow hook at the rear (not available with Revolution model)

Axles & Suspension
SAF disc brake axles with 430 mm disc diameter
Axles in off-road configuration
"Axles/chassis laser-aligned" to reduce tire wear and fuel consumption
Air suspension
Air bag pressure gauge
1st axle automatic lift axle, additionally electrically operable from the truck, including forced lowering and start-up assist, no truck installation required
"Hot-dip galvanized lift axle mechanism"

Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard chromed, with HDK screw coupling, fixed section, NW 48 mm (without hose connection)
Operation hydraulically via truck PTO
Hydraulic connection with hose and HDK screw plug NW = 48 mm, with knurled nut

Body
Steel round trough in "Stone Master Design" made of highly wear-resistant HB 400/450 steel. Sloped front wall with external hydraulic cylinder mount.
Interior with ladder at front wall.
Greenline – conical and aerodynamic body shape
Shovel and broom holder on the front wall exterior.
"Membrane" tailgate
Tailgate as hydraulic rear flap with large upward opening, approx. 2,200 mm clearance height.
Protective cover for tailgate.
Tailgate with rubber seal – Note! No guarantee on seal!
Note! Heat-resistant up to max. 170°C!
Continuous 4 mm side walls, floor 4/5 mm thick, wear- and weight-optimized construction.
Fliegl S.T.E.P. – swiveling standing platform at the front with foldable access ladder for side entry on the front left, only in combination with "Flip Top sliding roof"
Not printed without insulation
"Flip Top sliding roof," automatic rear lock as folding bows. Cover moves forward. Electrically operated, with 7-pin socket (charging plug) at the front without connection cable (pin assignment: Pin1: +/ Pin3: -), including loose tractor socket, no truck installation, operation on trailer and via wireless remote control.
7-pin spiral cable to truck for sliding roof, truck must have socket (pin assignment: Pin1: +/ Pin3: -)

この広告は自動翻訳されています。翻訳ミスがある可能性があります。